the configuration write guard is now required when the configuration
struct shall be mutated. the write guards locks multiple writers against
each other and also, more importantly, makes the writes synchronous to
the main loop. all code running in the main loop can now be sure that
(1) reads from the configuration struct are non-preemtive and (2) the
configuration struct as a whole is in a consistent state when reading
from it.
NOTE that acquiring a write guard from within the main loop's task will
immediately cause a deadlock and the watchdog will trigger a reset. if
writing from inside the main loop should ever become necessary, the
write guard must be updated to only lock the mutex but not wait for a
signal.
Due to a change in the Espressif Arduino core, the TX timeout for the HW CDC
(used in the ESP32-S3, for example) must not be set to 0, as otherwise, an
integer underflow occurs.
Removing the TX timeout is not necessary anymore anyways, because it is now
detected when CDC is not active, and attempts to write will return immediately
until the host read something again. Only when the transmit buffer becomes
full initially, the default timeout of just 100ms takes effect once.
For USB CDC (used with the ESP32-S2, for example), the timeout is not relevant
either.
fix calculation of the text baselines, using getAscent() in favor of
getMaxCharHeight(), which includes ascent and descent. this moves the
first text up and allows to insert margin between the lines until the
display area is fully utilized.
on large displays, if the small diagram is selected, keep the first line
rather low to avoid collision with the diagram y-axis label. in this mode,
there is still more space between the text lines as before, allowing for
improved readability.
This allows to enter a offset in kWh in the inverter properties which will be applied to the read Yield Total value of the inverter. Using this can set your total production to zero if you e.g. are using a used device.
chango to full Buffer Mode, remove picture loop,
because it's not worked.
look: https://github.com/olikraus/u8glib/wiki/tpictureloop
snprintf + public vars
- dispPowerSafe => true: PowerSafe Mode on
- dispLogo => true: showing Logo upper right corner
- dispContrast => possible to adjust the Display Contrast
change in date time, buffer deleted
Display-Constructor changed, reset goes to front
Arrow and Logo only shown, when production is on
Refactor OLEDDisplayClass to DisplayGraphicClass
